The most professional gasoline log splitter manufacturer >>

Maintenance and maintenance of wood chips

Date:17-08-07

   Why is the majority of users like the wood chip? Because the wood machine at work, the material in the crushing chamber can be fully and effectively crushed; high yield, low energy consumption, high efficiency; material crushing uniform; and in the use of the equipment, low noise, no pollution; , Easy to maintain. So how to maintain the wood chip?
   Wood chip machine in the work must pay attention to the spindle rolling bearing temperature does not exceed 65 ℃, such as more than 65 ℃, should immediately change the oil, if still invalid, you should remove the bearing with kerosene clean, coated with lubricants, and then work.
   Wood chip blade if the blunt or collapse, the four should be grinding at the same time to ensure the balance of the installation after the cutter, the end of the knife should also be replaced after the blunt, or seriously affect the quality of chipping.
1, pay attention to rust, the motor shall not be damp, not water, to prevent corrosion of parts.
2, pay attention to electricity safety, in strict accordance with the requirements of the motor signs wiring, and then a good ground.
3, the machine every time before the start, the lubrication point of oil, and check the rugged bolts are loose.
4, feeding mouth, cutting room to ban the extraction of metal, debris. If any abnormality is found, turn off the power immediately.http://www.cnsuperpower.com/