The most professional gasoline log splitter manufacturer >>

The use of wood chips and precautions

Date:17-08-16

   1, wood chips produced before the need to check the use of equipment, see the wood chip is not a loose loom, the transmission parts are not sensitive, etc .; see the use of equipment after the light, to ensure that the machine without any abnormal start to start the motor, adjust Good working speed. The control of the material, the moisture content of wood materials need less than 15 percent of the cost of damage.
   2, wood into the wood before the machine, the first look at the degree of dry and wet, pay attention to transport, storage environment, the material too much water will stick to the inside of the wood chips, in the wind easily into the group, will make the wood chip production value decreased, Spread the material to spread out, after drying in the fine grinding. Wood chip fragile parts have the use of the cycle, the use of a period of time to replace the wood chip grinding powder wear the better, the greater the production capacity of wood chips. Not wear and tear will affect the production capacity. The timing of the wood chips is affected by the shock of the voltage.
   3, wood chips after the normal work to prevent the wood with metal, brick, stone number into the machine; materials and machines all work no doubt, began to feed, feeding should be uniform and stable feeding, power to play out, Together to prevent the appearance of the card material. On the equipment of the smooth, must be based on the processing frequency of the number of smooth refueling moment, so that the goods to make a longer life, very good processing production. Normally the host grinding bearings are added once every 12 hours plus molybdenum disulfide lithium grease, which has 8 oil spots.
   4, the fineness of wood chips can be adjusted according to the direction of conditioning valve, the product should be timely view the fineness. Wood chips in the amount of fine grinding material will affect the amount of powder, adhesion will affect the loose, wood flour to advance the sieve, the particles will also affect the output value is too large. Wood chips can produce materials mainly wood, pine, Zamu, Yang wood, fir, bamboo, bamboo and other wood, and can also be used for thatch, straw, corn stalks, sorghum stalk and other fiber-like material.
   5, in the wood chips, chipper, wood damage machine production process, the use of vulnerable parts of the cycle, the use of a period of time to be replaced, wood chip grinding powder wear the better, the greater the production capacity of wood chips The Not wear and tear will affect the production capacity. The timing of the wood chips is affected by the shock of the voltage.

http://www.cnsuperpower.com/