Cause of issue:
1. Flying knife and the end of the knife gap is too large;
2. Flying knife wear blunt, or edge cracked too much;
3. End knife wear;
4. Screen damage;
5. The length of the raw material is too short;
6. Raw material moisture content is too low.
Method of exclusion:
1.Adjust the gap
2. Replace the knife (replacement);
3. Replace the bottom edge or blade at the end of the knife;
4. repair or replace the screen;
5. Control the length of raw materials or long, short material doping feed;
6. soaking raw materials, water content control in about 40%.