The Specific Work Of Chipper Shredder Maintenance And Maintenance

Home / News / The Specific Work Of Chipper Shredder Maintenance And Maintenance
Chipper shredder is a widely used shredder equipment, so it has more vulnerable parts inside, and these vulnerable parts need to be maintained and maintained at a time after using for some time, to extend the life of these vulnerable parts Service life, reduce the maintenance cost of the chipper shredder. Doing the same way will increase the output and crushing efficiency of the chipper shredder, and extend the service life of the equipment. What are the specific tasks for the maintenance and maintenance of the chipper shredder?

  Lubricant should be injected into the bearing every 300 hours of work, and the bearing should be taken out and cleaned carefully before injecting, and the inside of the bearing housing should be cleaned before injecting lubricating oil to avoid contamination of the lubricating oil by dirt. The use effect is reduced. Injecting lubricating oil into the bearing is mainly used to improve the lubricity of the bearing and reduce the wear caused by it during work.

  And every time the chipper shredder works for some time, we have to check whether the tightness of the V-belt is appropriate because the tightness of the V-belt will change after the chipper shredder works for a long time. If it is too tight, it will cause the chipper shredder's bearings and motor. The temperature continues to rise, and in serious cases, it may even cause the bearing to deform and the motor to burn out. If it is too loose, it will cause the chipper shredder to have insufficient crushing power and blockage, so we must check it whenever the chipper shredder has been working for some time. Check whether the tightness of the V-belt is appropriate.