Logging machine protective cover manufacturers: how to maintain the logging machine?

This combined logging rig has a variety of optional different types of operation modes. Next, I will discuss the current situation and future development trend of these two types of logging rigs based on my many years of work experience. research provides valuable reference.

    Logging machine protective cover manufacturers: how to maintain the logging machine?

    1. Running-in period: The newly-produced machine is in the running-in period until the third oiling period. When using, do not let the engine run at high speed with no load, so as not to add extra burden to the engine during the running-in period. After five to fifteen refuelings, the chainsaw reaches a lot of power.

    2. Check and check the overall appearance of the chainsaw before working every day: check the throttle, throttle clip, combination switch and various control devices; check the function of the chain brake; check the lubrication of the chain; check the sharpness of the chain; check the chain tension; check the guide Plates for wear or damage; check that the chain is following when the engine is idling; check the chain pins of the sprockets.

    3. Check after get off work every day: clean the entire chainsaw; clean the entire air cooling system.

    4. Check items after each refueling: Check the appearance of the entire chainsaw. Check the throttle, throttle clip, combination switch and various operating devices; check the function of the chain brake; check the chain lubrication; check the chain tension; check whether the chain follows when the engine is idling.

    5. Check after get off work every week: clean and flip the chain guide rail; remove the burr on the guide plate; check the wear of the sprocket; check the rubber shock absorber of the chainsaw.

    6. Items to be checked after get off work every month: check the filter in the gasoline tank; clean the gasoline tank; clean the lubricating oil tank; clean the cylinder radiator.

    7. The air filter is dedusted every 25 hours, and the maintenance time should be shortened when the dust is large. Adjust the damper to the choke position to prevent dust from entering the intake duct. Clean the foam filter in a clean, non-flammable cleaning solution, such as hot soapy water, and dry it. Replace felt filter. If it's not too dirty, tap or blow lightly, but don't clean the felt filter. Note that damaged filter elements must be replaced. During installation, care should be taken that the marked side of the felt filter should be placed inside the filter housing.

    8. After every 25 hours of use, remove the spark plug and remove the dust on the electrode with a wire brush. It is recommended to adjust the electrode gap by 0.6 to 0.7 mm.

    9. If the engine power is insufficient, it is difficult to start or the idle speed fails, first check the spark plug. Clean contaminated spark plugs, check electrode distance and adjust if necessary. To avoid sparks and fire hazard, if the spark plug has a separate connector - be sure to screw the nut on the threads and tighten, pressing the spark plug's plug tightly against the spark plug.

    10. Clean the fuel filter every 25 hours.

    11. Remove the muffler every 50 hours, clean the exhaust port and muffler outlet, and put carbon on it.