Can Rapid Splitter Process Wet Material

　　The appearance of the rapid splitter has turned the waste branches generated during the pruning of fruit trees into biomass fuel, realizing recycling and protecting the environment. However, during the operation, many people have such a question, can this equipment process wet materials?

　　Moisture content is an important factor affecting the working performance of rapid splitter. Rapid splitters with different principles have different requirements for material moisture content. Higher moisture content is not conducive to the processing of materials. When the moisture content is below 6%, the processing effect is good, and the moisture content has such a great impact on the work of the rapid splitter, and it can be seen that it also has a great impact on the output and performance of the equipment.

　　Under normal circumstances, the texture of the wet wood is fibrous when it is hit by the hammer during processing, so if there is fiber, it will affect the work of the hammer during processing. Such a rapid splitter works The efficiency will be lower, and the output of the work will be much smaller. Relatively, if the dry wood is used, the fibers in the middle will be much less, so if the hammer and the blade hit the material, they will be smashed very easily. As a result, the wood can be pulverized more finely, and the output requirements can be met.

　　Most of the rapid splitters are processed by the dry method, but some materials have high water content, and the processing is slightly difficult when the humidity is slightly too high. However, for some materials with high humidity, they can be processed after drying first. It is very important to choose good wood and rapid splitter equipment.

　　In summary, the rapid splitter should not be used to process wet materials as much as possible, because it will reduce the processing efficiency of the equipment and damage some parts of the equipment. You can dry the wood first, and then use the rapid splitter for processing.