Petrol Log Splitter's Reasons For Not Feeding

　　Through interviews and survey feedback, customers always encounter some difficult problems in the process of using petrol log splitter. In line with the principle of customer convenience and customer service, we will carry out some knowledge explaining activities on petrol log splitter products from time to time, bring out problems that customers often encounter or are difficult to solve, discuss with everyone and find solutions, hoping to help customers and make better use of our products. Then, we will explain the problem of petrol log splitter not feeding on this period of explanation activities. Next, please look at the following articles:

　　I. Reasons for petrol log splitter's Non-Feeding:

　　In the production process of the equipment, some users will reflect that the equipment does not feed, causing such phenomena as the aging of hammerhead, sealing of screen holes, the high water content of crushed materials (more than 14%) will block the equipment or the conveying equipment is not matched, which will lead to no feed.

　　Second, the solution:

　　1. petrol log splitter is equipped with an automatic feeding device, which completely solves the problems of slow feeding or no feeding. The adopted automatic feeding device is a chain disc conveyor. The chain disc conveyor adopts scraper chain strips so that the conveyed materials do not slip, and double pressure rollers are adopted at the feed inlet to extrude the materials, so that fluffy materials enter the pressure rollers to reduce the volume, and the materials become denser and easier to crush. This kind of equipment only needs one feed, as long as the material is placed on the conveyor, it will automatically enter the machine cavity to be crushed.

　　2. Change the feeding mode and control the feeding amount by increasing the feeder. There are two kinds of feeders, manual and automatic. Users can choose the appropriate feeders according to their actual situation.

　　When petrol log splitter does not feed, the operator should immediately realize what the problem is based on past experience. A short-term solution can effectively prevent the equipment from being damaged inside. First of all, it is necessary to control the feed rate to avoid the abnormal operation of the equipment caused by excessive feed rate. Second, it is necessary to pay more attention to the operation of the equipment during use. Once any change is found, it is necessary to stop the machine and check it according to the correct steps. It is not allowed to check while running, which will pose a threat to personal safety.